Table of Contents
Advertisement
12.
SOFTWARE SETUP
12.1 AWARD SETUP PROGRAM
The TEK-CPCI-1000 uses the AWARD BIOS setup program to configure data in the CMOS
RAM. This program is EEPROM located and may be accessed by pressing the DELETE key
at the appropriate time during system boot.
CAUTION
Before modifying CMOS setup parameters, insure that the W8 jumper
(battery) is installed to enable the CMOS backup.
(See Section 10 - Setting Jumpers)
To run the AWARD Setup program, proceed as follows:
2.
Turn on or reboot the system.
3.
Hit the DELETE key before or when the message - "PRESS DEL TO ENTER
SETUP" appears near the bottom of the screen.
4.
The main menu appears on the screen.
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP/PCI CONFIGURATION
LOAD BIOS DEFAULTS
LOAD SETUP DEFAULTS
Esc
:
Quit
F10
:
Save & Exit Setup
Time, Date, Hard Disk Type...
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
INTEGRATED PERIPHERALS
SUPERVISOR PASSWORD
USER PASSWORD
PASSWORD SETTING
IDE HDD AUTO DETECTION
4DD LOW LEVEL FORMAT
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
↑ ↓ → ←
(Shift)F2
12-1
:
Select Item
:
Change Color
Advertisement
Table of Contents
