Simm Installation - Teknor Industrial Computers TEK-CPCI-1000 Technical Reference Manual

TEK-CPCI-1000 Technical Reference Manual
60ns maximum access time EDO DRAM devices are recommended.
The following table shows examples of recommended DRAM devices supported by the
board. Many other models are also available and function equally well. Users are encouraged
to check with their local distributors for comparable substitutes.
DIMM
2M*72 (ED0) - 16MB modules
(SPD EPROM, ECC)
4M*72 (SDRAM) - 32MB modules
4M*72 (ED0) - 32MB modules
(SPD EPROM, ECC)
8M*72 (ED0) - 64MB modules
(SPD EPROM, ECC)
16M*72 (SDRAM) – 128MB modules
16M*72 (ED0) - 128MB modules
(SPD EPROM, ECC)

6.2.2 SIMM Installation

To install the SIMMs in the sockets, proceed as follows:
To remove the SIMMs from the sockets, pull on the retaining pegs located on each side of the
SIMM socket. Once the module has snapped out of the socket, pull gently on it.
VENDOR
ROCKY MOUNTAIN RAM
ROCKY MOUNTAIN RAM
ROCKY MOUNTAIN RAM
ROCKY MOUNTAIN RAM
ROCKY MOUNTAIN RAM
ROCKY MOUNTAIN RAM
1. With the board flat on the table, turn it so that
the front plate is on the left.
2. Hold the module with the notch on the bottom
right facing you, and insert the fingers into the
socket at a 70° angle from the board. Always
start inserting the module in the socket nearest
the top edge of the board
3. Snap the module to a vertical position in the
socket. The module is fully inserted when the
retaining pegs snap into the holes at each end
of the module.
4. Work your way by inserting the other
modules, one by one, towards the lower edge
of the board.
6-4
PART NUMBER
2x72CEQ
4x72CQ2x8S4E
4x72CEQ
8x72CEQ
16x72CQ8x8S4E
16x72CEQ