Software Programming; Description Of Software Booting - Siemens SL 10 Service Manual

7 Software programming

The software of the SL10 handset is programmed directly from a PC using a bootadapter as
an interface beetween serial port of the PC and the mobile. Because the SL10 does not carry
an external connector (e.g. like S6) an additional service adapter is needed.
This service adapter replaces the battery of the phone and contacts three pads inside the
battery department of the telephone. Via this contacts and the bootadapter a serial
communication is established between the SL10 and the PC.

7.1 Description of software booting

Connect COM-port of PC to the
bootadapter using the enclosed RS232
cable.
Afterwards plug in AC-Adapter: If
connected correctly the „Power" lamp
will be active.
Switch off the SL10 handset and remove
the battery. Insert the service adapter
instead of the battery, connect it to the
boot adapter and plug in the AC-adapter of the service adapter.
Copy bootsoftware to the PC and follow the instructions in the file „readme.txt".
Ordering number of Bootadapter:
Ordering number of Service Adapter: L36880-N1601-A130
Service Manual SL10
sm_sl10_lvl2_v11.doc
Bootadapter
RS-232
cable
L24857-F1006-A30
The bootadapter comes complete with AC-Adapter,
RS-232 and handset connection cable.
The service adapter is shipped incl. AC-Adapter
V1.1
Page 20 of 22
Private Communication Systems
Mobile Phones
Connection Cable
AC-Adapter
AC-Adapter
Service
Adapter
PN MP ST
R. Fleuren
05/98