Table of Contents
Advertisement
S I E M E N S
C62 Level 2 Service Manual
7
Mobile Software Programming
Due to the separation of common mobile software and language package, it is possible to fulfil the
demands of the market requiring customization and flexibility.
As a consequence the software programming process in the LSO is divided into two different
steps as followed:
Software update to latest version of signalling software.
1.
Programming of customer specific language package.
2.
Mobile Software Updating
Update the latest signalling software and language package with the flash programmer. The
software for the C62 is loaded from a PC directly. Hardware interconnection between the mobile
and the PC is shown in the figure below. See installation instructions in the following section.
Dongel
C62 Software Programming Setup
Flashing tools
The Flash Programmer software tool is used for flashing. The latest software release, a language
package, a customization package and a SIM lock package can be chosen. Flashing requires a
fully charged battery or an battery dummy connected to a 4 V power supply.
The flashing of the phone is done via the SLIM-Lumberg connector. In order to have a F30032-
P77-A2, a Bootkit (part no: F30032-P258-A1 connected with a standard RS 232 cable, a
standard Dongle F30032-P28-A1 and a standard Siemens charger (Euro (ETC-500), UK (ETC-
510), China (part no.x), US/Taiwan (part no.x) or Australia (part no.x)) or a Siemens widerange
charger (Euro (ETC-500), UK (ETC-510).
Copyright © Siemens Pte Ltd.
All Rights Reserved
ICM MP CCQ SLI RHQ
P T E L T D
21 of 47
F30032-P77-2
C62 Level 2 manual V1.1
Internal Use Only
Advertisement
Table of Contents
