Assembling The Mobile - Siemens SL 10 Service Manual

4.3.4 Assembling the Mobile

1. First insert the slide stop and the spring into the top of the base. The spring has to be
inserted into the gap which is closer to the upper end of the telephone (where the infrared
interface is located)
1. Now mount the slide on the guide rails in the top part
of the base.
Caution!
Applying too much pressure will damage the plastic parts, especially the upper part of the
slide is very sensitive.
1. Close the slide.
1. Connect the flexible cable to the plug on the control module and affix the retaining clip to
the plug.
1. Insert the interconnected slide/top of the base into the
bottom of the base
Caution!
First secure the catch to the top edge of the housing so
that the flexible cable is not damaged. Afterwards fix
the catches (see figures below).
2. Screw the torx countersunk screws into the battery compartment and into the housing.
Cover the housing screw with the plastic cap.
3. Finally, screw in the antenna and insert the SIM card rack bearing the SIM card.
Service Manual SL10
Sm_sl10_lvl2_v11.doc
Private Communication Systems
V1.1
Page 12 of 22
Mobile Phones
PN MP ST
R. Fleuren
05/98