Table of Contents
Advertisement
The following two figures are the printouts of DIRECTION 0 and 1.
Note: The printer driver may overwrite the setting set from the front panel.
Print Mode: (None/Batch Mode/Peeler Mode/Cutter Mode/Cutter Batch)
This option is used to set the print mode. Printer default setting is Batch Mode. When entering this
list, the print mode to the right side of the " >" icon is the printer current setting.
Press
and
setting. Press
Printer Mode
None
Batch Mode
Peeler Mode
Cutter Mode
Cutter Batch
Note: The printer driver may overwrite the setting set from the front panel.
Offset:
This option is used to fine tune the media stop location. Press the
cursor from left digit to right digit, and press the
"9". Press the
and return to the previous menu. The default value is +000.
to select a different print mode and press
key to cancel the setting and return to the previous menu.
Description
Next label top of form is aligned to the print head burn line location. (Tear Off
Mode)
Once image is printed completely, label gap/black mark will
be fed to the tear plate location for tear away.
Enables the label peel off mode.
Enables the label cutter.
Cuts the label once only, at the end of the printing job.
button to set the value into printer. Press
button to set the value from "+" to "-" or "0" to
14
button to enable the
button to move the
key to cancel the setting
Advertisement
Table of Contents
