First Degree Fitness E-520 Fluid Rower Owner's Manual page 16

Bungee Cord Replacement. Dealer Assistance Required
(Expect 2-5 years bungee life in commercial use. Damage during initial rower assembly is not covered
under warranty)
1. Unhook Bungee Cord Hook. Remove com-
puter mount with 6mm Allen key.
Spacer
5. Attach the Spacer to the end of the rower pul-
ley and use the "ear" to help thread the strap
into the machine. Note that the Spacer may re-
quire being tilted just slightly to allow it to pass
through.
Note: A light tap may be required if the black inner Spacer will not pass inside the frame.
Reassemble. Note: A tight C-Clip mounting indicates the process should be repeated as the belt is
jammed up.
16
3. Remove the
Belt Pulley and
the Spacer. Un-
hook the Bungee
Cord End from the
Pulley and re-
move by pulling
out from the bot-
tom.
Ear
Tilt Spacer
slightly
Pulley
Sticker
2. Carefully peel
back and remove
the Belt Pulley Sticker. Then remove C-Clip and
Black Spacer as shown.
4. Feed the new Bungee Cord from below and
reattach end strap to the Belt Pulley.
Reattach the Bungee Hook to the end of the
Seat Rail, install outer Spacer, C-Clip and
Sticker. Test for proper installation. If the C-
Clip cannot be reinstalled, then remove Pulley
and try again as the Strap may be jammed.
Spacer
C-Clip
Ear Strap
The Joiner should be
able to reach this po-
sition.