Table of Contents
Advertisement
WARNING The Grey and Black cables coming out of the Outside Unit are generally long
enough to allow for connection to the Control Unit. If it is not so, use the extension cables
and perform the following operations:
1) Connect the two cables coming from the centre of the OUTSIDE UNIT to the two supplied
extensions, waterproofing the connectors using the two pieces of heat-shrinking tube.
2) Accomodate the cables into a protection raceway up to the point where the cables go
into the vehicle, using the suitable supplied fairlead.
7
2) Fasten the external powered unit to the four stud
bolts of the plate, using the four nuts supplied with
the equipment.
Connection with extension
Caution:
to ensure ideal nut tightening and
prevent possible pin breaks,
tighten the nut with a torque
wrench set to 8 Newtons/metre
Seal the fairlead carefully so as to
prevent any infiltration by water
Hide quick links:
Advertisement
Table of Contents
