Table of Contents
Advertisement
When they are present, remove the transparent films from the BASE PLATE (Fig. 5).
4) Clean the lower part of the BASE PLATE carefully, applying a layer of glue on the
whole surface (e.g. SIKAFLEX).
5) Fasten the BASE PLATE to the roof (short side towards the vehicle driving direction).
6) Apply a layer of silicone all around the BASE PLATE in order to make it completely
waterproof (Fig. 5A)
1) Fasten the OUTSIDE UNIT on the base plate and lead the two cables through any of
the 4 existing grooves, according to the position as shown on Fig. 6.
WARNING: When performing this operation, do not draw the two cables forcefully, as this
might pull them out.
Outside Unit Installation
6
Hide quick links:
Advertisement
Table of Contents
