Carefully lift grill grates off of grill
area and set aside.
Remove sear plates and set aside.
Remove tiedowns from burners
and warming shelf.
Reinstall sear plates. Make
sure sear plates are resting on pins.
Carefully slide grill completely
into outdoor enclosure.
Now go to the "Checking and
Adjusting Burners Section."
If converted to
Securely tighten all gas connections.
If connected to LP, have a qualified
person make sure gas pressure does
not exceed 11" (28 cm) water column.
Examples of a qualified person
licensed heating personnel,
authorized gas company personnel,
authorized service personnel.
Failure to do so can result in death,
explosion, or fire.
Make gas connections.
L.P./Propane: A 20 lb. L.P. tank must be
purchased separately. Install the tank into
the compartment below the grill and
screw the hose/regulator assembly to
tank as shown.
supplied with the
grill must be used.
assembly specific to your model, is
available from your outdoor grill dealer.
If converting to natural gas, see
conversion kit requirements and "Gas
supply requirements" section. Follow
instructions included with kit.
Turn on the gas supply. Wait a few
minutes for gas to move through the gas
Test all connections by brushing on
an approved non-corrosive leak-detection
solution. Bubbles will show a leak. Correct
any leak found.
Go to "Checking and adjusting the