Installation - Culligan SILVER SERIES Installation And Operating Instructions Manual

Installation

PLACEMENT
Refer to Figure 1 for system placement.
• Set the media tank on a solid, level surface near water, drain and electrical facilities. Place the outlet (black
coupling) of the tank on the left.
• Set the brine system on a flat, smooth, solid surface as near the media tank as possible.
MOUNT THE CONTROL VALVE
See Figure 2 for a visual on mounting the control valve to the tank.
• Remove and discard the protective covers on the tank couplings.
• Lubricate the o-rings on the tank couplings with silicone lubricant.
• Place the control on the tank couplings and press down firmly.
NOTICE: The white tank coupling is the inlet, and should be located on the inlet side (right side) of the control.
• Install the u-clamps on both sides of the control and secure with the screws.
TWELVE INCH SOFTENERS
As shipped from the factory, each control is equipped as a 9-inch unit. A 12-inch eductor nozzle and backwash flow
control are included with each unit for conversion for use with the 12-inch tanks.
NOTICE: To prevent injury, convert unit to a twelve-inch configuration prior to installation.
Refer to Figure 3 for a visual on changing the eductor nozzle and the backwash flow control.
Eductor Nozzle Replacement:
• Remove the three screws on the eductor cap and remove the cap.
• Remove the eductor assembly.
• Remove the eductor screen from the assembly
• Remove the blue nozzle and replace it with the beige nozzle. Make sure to put the o-ring on the beige nozzle.
• Reverse the procedure to reassemble. To prevent leaks, ensure that the gasket is in the proper position.
Backwash Flow Control Replacement:
• Remove the drain clip and pull the drain elbow straight off.
• Remove the backwash flow control located behind the elbow. Put the #3 restrictor in its place.
NOTICE: The number on the flow control should face into the valve body.
• Reverse the procedure to reassemble.
FIG. 1
6 CULLIGAN SILVER SERIES WATER SOFTENER
™