Manual Cycling - Culligan SILVER SERIES Installation And Operating Instructions Manual

Manual Cycling

The Culligan
®
numbers do not appear, or change, until the motor stops.
1. Press the status button to move past steps 1-10 until the display
is blank. Push the up arrow. The number "11" icon will light up.
An "H" will appear in the display. The control is in the HOME
position. Pressing the regen button once will light the 'REGEN'
icon.
2. Press the regen button one more time. The 'REGEN' icon will
blink, and the motor will advance the control. A '1' will appear.
The unit is now in the BACKWASH position. The numbers to
the right indicate the time remaining for the cycle.
3. Press the up arrow. A '2' will appear in the display, along with the
cycle time remaining. The control is in the BRINE DRAW/SLOW
RINSE cycle.
4. Press the up arrow. A '3' will appear in the display, along with the
cycle time remaining. The control is now in the FAST RINSE/
BRINE REFILL cycle.
5. Press the up arrow. An 'H' will appear in the display. The unit is in
the HOME position. The 'REGEN' enunciator is no longer blinking.
NOTICE: On Aqua-Sensor® controls the display will initially
display "H 20" and proceed to count down to zero. This is the 20
minute signal delay built into the Accusoft® microprocessor. The
control will not allow another regeneration to occur during this 20
minute period.
6. Press the status key. Time-of-Day appears in the display.
18 CULLIGAN SILVER SERIES
™
microprocessor can be indexed through the various regeneration stages. For all steps, the cycle
WATER SOFTENER