Mitsubishi Electric JT-MC206GS-W-E User Manual page 19

(5) Heater (PTC)
1 Disconnect the heater lead wires from the power circuit board (JT-
33P). → See (4) 1 to 2 and 4 to 5.
2 Unscrew the nozzle clamping screws.
(Four PTT screws 4 x 14, indicated by )
Assembly precaution
Tighten the screws in a crisscross pattern.
3 Remove the heater (PTC) with the fix plates (heater).
Assembly precautions
• Run the lead wires through the groove of the blower cover.
(Indicated by )
• Take care not to pinch the lead wires.
Assembly precautions
• Run the heater lead wires as shown in the picture at right.
• Fit the thermal fuse parts into the groove of the fix plates (heater).
(Indicated by )
─ 19 ─
Nozzle
Heater (PTC)