Mitsubishi Electric JT-MC206GS-W-E User Manual page 20

(6) Blower (assembly) (Thermal fuse of the motor)
1 Disconnect the blower lead wires from the power circuit board (JT-
33P). → See (4) 1 to 2 and 4 to 5.
2 Push the cord bush into the blower cover. (Indicated by )
Assembly precautions
• Install the cord bush as shown in the picture at right.
• Make sure that there is no slack in the lead wires inside the blower
cover.
3 Unscrew the duct clamping screw.
(One PTT screw 4 x 14, indicated by )
Assembly precaution
Set the duct in the groove of the blower cover. (Indicated by )
4 Unscrew the blower cover clamping screws.
(Four PTT screws 4 x 14, indicated by )
Assembly precaution
Tighten the screws in a crisscross pattern.
─ 20 ─
Blower cover
Cord bush
Duct
Blower cover