Mitsubishi Electric JT-MC206GS-W-E User Manual page 9

Hand dryer
Hide thumbs Also See for JT-MC206GS-W-E:
Table of Contents

Advertisement

(5) Operating procedures for the test mode: indicating the number of operation/
operating time
1 How to start the test mode: Turn ON the power switch while holding down both of the heater switch and air
2 Lighting status of the heater lamp shows the contents of the indication.
• The heater lamp ON : The cumulative number of operation of the blower
• The heater lamp OFF : The cumulative operating time of the blower
Use the heater switch to switch between ON and OFF.
3 The air speed lamps (HIGH and LOW) and check lamps (1 and 2) indicate the cumulative number of operation.
• Display digit: A 4-digit display ( Check lamp 2 (LED 6) indicates a hundred-thousands digit, check lamp
• Display range: 100 to 999900 times
• Display method: The number of blinking (ON for 0.2 seconds/OFF for 0.2 seconds) of each lamp indicates
4 The air speed lamps (HIGH and LOW) and check lamps (1 and 2) indicate the cumulative operating time.
• Display digit: A 4-digit display ( Check lamp 2 (LED 6) indicates a thousands digit, check lamp 1 (LED 5)
• Display range: 1 to 9999 hours
• Display method: In the same way as described above. (See examples 1 and 2.)
Example 1: In the case of 999900 times or more, or 9999 hours of more
Check lamp 2
Check lamp 1
HIGH lamp
LOW lamp
Example 2: In the case of 246800 times, or 2468 hours
Check lamp 2
Check lamp 1
HIGH lamp
LOW lamp
Example 3: In the case of 100 times or less, or 1 hour or less
Power lamp: Fast blinking (ON for 0.1 seconds/OFF for 0.1 seconds)
HIGH lamp, LOW lamp, check lamp 1, and check lamp 2: OFF
5 During the test mode, the hand dryer only performs the above indication, and does not perform any other
operations including blowing air.
6 How to finish the test mode: Turn OFF the power switch, and wait for about 30 seconds. Turn ON the power
speed switch. At this time, the power lamp blinks fast (ON for 0.1 seconds/OFF
for 0.1 seconds).
1 (LED 5) indicates a ten-thousands digit, HIGH lamp (LED 4) indicates a
thousands digit, and LOW lamp (LED 3) indicates a hundreds digit.)
the numeric value for each digit, and the pattern of blinking repeats in a 6-second cycle.
(See examples 1 and 2.)
indicates a hundreds digit, HIGH lamp (LED 4) indicates a tens digit, and
LOW lamp (LED 3) indicates a ones digit.)
2
3
1
1
2
3
1
2
3
1
2
3
(0.2 seconds + 0.2 seconds) × 9 = 3.6 seconds
1
2
1
2
3
1
2
3
1
2
3
switch again, and then the mode returns to the normal operation.
4
5
6
4
5
6
4
5
6
4
5
6
6.0 seconds
4
6
4
5
6
4
5
7
6.0 seconds
─ 9 ─
7
8
9
7
8
9
7
8
9
7
8
9
8
Repetition
Repetition

Advertisement

Table of Contents
loading

Table of Contents