Dhcp Mode - Digitus RedRapid X User Manual

bridged LAN ports. When "IGMP Snoop" (Internet Group
Management Protocol Snoop) is enabled, the router can make
intelligent multicast forwarding decisions by examining the
contents of each frame's IP header. Without the function, the
router will broadcast the multicast packets to each port and
may create excessive traffic on the network and degrade the
performance of the network.
Ethernet to Enable/disable the 'Ethernet to Wireless Blocking', when this
Wireless function is enabled, the traffic between Ethernet and wireless
Blocking interfaces is not allowed.
When you finish, click 'Apply Changes'. You'll see the following message
displayed on web browser:
Press 'Continue' to save the settings made and back to web management
interface; press 'Apply' to save the settings made and restart the router so the
settings will take effect after it reboots.

5.2.3.1. DHCP Mode

You can configure your network and the router to use the Dynamic Host
Configuration Protocol (DHCP). This page allows you to select the DHCP mode
that this router will support.
There are two different DHCP Modes: DHCP Serve and DHCP Relay. When the
router is acting as DHCP server, please configure the router in the "DHCP
Server" page; while acting as DHCP Relay, you can setup the relay in the "DHCP
Relay" page.
52