Table of Contents
Advertisement
Basic Settings
Disabling the Life Warning Display
This section explains the steps required to configure the warning message
display, bar code, R-MIC and brightness of the LCD panel using the
Configuration Menu on the control panel.
Note
For information about "Date & Time" of the Configuration Menu, refer to
"Setting the Date and Time" (page 23) in Chapter 2, "Installation".
When the device is shipped from the factory, the life warning is set to display.
This default setting is recommended. (Thus the following setup is unnecessary.)
Change this setting in "Warning" of the Configuration Menu.
Note
The displaying of the life warning can also be set through a browser.
1
At the status display, press the [MENU] button for 0.5 second.
2
Press the V button once to select "2.Configuration", then press the
[ENTER] button.
3
Select "2.Warning", then press the
[ENTER] button.
"Warning" appears.
4
Use the V and v buttons to select "YES", then press the [ENTER] button.
The default factory setting is "YES".
Select "NO" to not display the warning.
5
When "[ENTER] to activate"
appears, press the [ENTER] button.
The life warning is now set.
The display returns to "Warning".
Configuration
1.Date & Time
2.Warnig
3.Bar Code
4.R-MIC
5.LCD Contrast
Warning
Enable
YES
Warning
Enable
YES
[ENTER] to activate
Chapter 3 Basic Usage
12:34
12:34
12:34
41
Advertisement
Table of Contents
