Table of Contents
Advertisement
SCSI ID
Enter the subnet mask.
Gateway
Enter the IP address for the default gateway.
DNS (Primary)
"DNS (Primary)" is not supported.
DNS (Secondary)
"DNS (Secondary)" is not supported.
5
Click "Submit".
The library is configured.
Note
If the IP address assigned by a DHCP server is being used, enter the current
IP address in the "Address" field of the browser, and then click "Submit".
The current IP address can be checked with "Network" on the Configuration
Menu. For Information about how to check, refer to "Operation example"
(page 37) in "Control Buttons" in Chapter 3, "Basic Usage".
6
Restart the AIT library.
The settings are activated.
In "SCSI ID", the SCSI IDs and SCSI parities of the AIT library and AIT drives
can be set. After configuring, the AIT library must be restarted.
Caution
Do not use the same SCSI IDs on a same SCSI bus.
Note
The SCSI IDs and SCSI parities can also be set using the SCSI Menu of the
control panel.
1
Click "System Configuration" on the Library Administration Menu, then
click "SCSI ID".
Chapter 6 Using the Library Administration Menu
70
Advertisement
Table of Contents
