Mounting The Shift Mechanism - KTM 250 SX-F 2006 Repair Manual

1

Mounting the shift mechanism

– Mount the locking lever
spring . Apply Loctite 243 to the screw and tighten to 6 Nm.
4
– Press the locking lever away from the shift drum and slip on the
shift lock.
NOTE: the flat surfaces on the shift lock are not symmetrical.
– Apply Loctite 243 to the shift lock and tighten to 10 Nm.
– Mount the preassembled shift shaft in the case (do not forget the
stop disk), press the shift rail back and allow to engage in the shift
lock.
– Mount the shift lever and shift through the gears while turning the
main shaft; remove the shift lever again.
with the washer , bushing
1 2
2
1
4
3
6-6
and
3