6-5
1
3
4
5
– Mount the suction pump rotors
The marks should no longer be visible when mounted.
– Insert the needle roller
inner rotor.
– Fill the oil pump with engine oil.
– Insert a new O-ring
Loctite 222 to the screws and tighten to 6 Nm.
2
– Insert the preassembled kickstarter shaft in the seat of the engine
case; slightly turn the kickstarter shaft in a clockwise direction until
the kickstarter ratchet gear
the kickstarter spring again.
6
with the marks facing the case.
1
in the recess of the oil pump shaft and
2
and mount the oil pump cover
3
stops behind the stop plate
5
. Apply
4
. Attach
6