KTM 250 SX-F 2006 Repair Manual page 28

3-7
2
4
5
8
1
3
6
7
– Mount the engine vent
1
– Mount both upper engine braces
yet.
NOTE: the hose the engine vent should run between the two engine
braces.
– Screw the hot start control
– Connect the generator connector
connector . Attach the wiring harnesses with cable clips.
5
– Mount the clutch slave cylinder
(M6x20) and tighten to 10 Nm.
– Position the chain securing guide
tighten to 10 Nm. Tighten the screw on the chain roller.
– Connect the spark plug connector
.
but do not tighten the screws
2
into the carburetor.
3
and throttle potentiometer
4
, screw in both front screws
6
, mount the M6x25 screw and
7
.
8