Bull Escala EPC400 Connecting Manual page 64

16.Once the prompt> is displayed, if the Boot is not automatic, then:
type
and press
17.Two or three windows appear after the starting has completed:
a window of Setup and Configuration (upper left),
a telnet window,
a system console window corresponding to the serial line RS232 (S1 plug of a EPC
node) provided that the X terminal is directly wired to a node's S1 port.
18.Inside the Setup and Configuration window:
select Window Manager
and click on the icon to run NCD Window Manager.
19.In the telnet window, or after opening New Telnet in TERMINAL of the Setup window:
type in the Service field, the IP address of another node
and hit OK to establish the telnet session.
Open as many New Telnet windows as there are nodes left; go to the Setup &
Configuration window,
select Terminal
then New Telnet
then type the node IP address in the service field.
20.In order to have a full automatic boot when powered up,
select the SETUP menu in the Setup and Configuration window, then:
select Change Setup Parameters
then Booting
validate Boot automatically at power–up
Save the configuration by choosing Apply.
21.In order to have an automatic establishment of additional telnet session to other nodes,
select in the Setup window
SETUP
Change Setup Parameter
– Commands and Startup
then for each node add the IP address within the command line
term –ctype telnet <@IP> –geometry ...–title <node name>...–n<node abbr>...
and save the configuration by hitting Apply
22.At the next power–up put back the PCMCIA board to write unable.
6-34
EPC Connecting Guide
>BL
ENTER