Table of Contents
Advertisement
Smart Touch Cabin Control Installation & Operations Manual
INTRODUCTION
The Smart Touch Control is a microcontroller-based unit designed for use with direct expansion, reverse-cycle air conditioning
systems.
R
T
M
EAD
HIS
ANUAL
Read this manual completely before you proceed with the installation and operation of the Smart Touch. If you have questions
or require assistance with your Smart Touch control, contact the Dometic Marine Service Department at +1 954-973-2477.
The Smart Touch is covered under existing Marine Air Systems Warranty Policy. Incorrect installation, neglect and system
abuse are not covered under Marine Air Systems warranty policy.
F
EATURES
S
TANDARD
•
User-friendly touchscreen display requires no manual for basic operation.
•
5-volt logic and microcontroller located in the display.
•
Automatic and three programmable manual fan speeds.
•
21 programmable parameters for custom installations.
•
Moisture Mode for controlling relative humidity.
•
De-icing cycle to prevent evaporator coil icing.
•
Programmable compressor staging delays.
•
Universal 220/115-230 volt, 50/60 Hz AC power supply.
•
Nonvolatile memory retains settings without batteries.
•
Programmable display-brightness control.
•
Programmable failsafe modes.
•
Fits Vimar® Eikon and Eikon EVO switch bezels.
O
PTIONAL
•
Outside air temperature sensor.
•
Alternate air temperature sensor.
•
Pump Sentry water sensor.
•
Electric heating control capabilities.
•
CAN-bus network capability.
•
Air Filter Cleaning or Replacement Timer.
•
Low-Voltage Monitor.
This manual provides all necessary information for proper installation and operation of the Smart Touch Display. Poor
installation and misunderstood operating parameters will result in unsatisfactory performance and possible failure.
L-3380 ENGLISH
B
P
EFORE
ROCEEDING
INTRODUCTION
1
Advertisement
Table of Contents
