Table of Contents
Advertisement
User's Manual
NOTE: The record action for motion events will not be affected by the Motion Ignoring function.
Highlighting Daytime Setup and pressing the
Highlight the Actions 1 and Actions 2 tabs and the Motion Detection Actions 1 and Actions 2 screens display.
Figure 50 — Motion Detection Actions 1 screen.
Highlight the box under the Record heading and press the
as many cameras with that camera as you wish. If the DVR detects motion on the selected camera, it starts recording
video from all the associated cameras.
NOTE: For the Record action, the camera you select should be set to the Event or Time & Event recording mode
in the Record Schedule setup screen.
Highlight the box under the Alarm-Out heading and press the
associate as many Alarm-Outs with that camera as you wish. When the DVR detects motion on the selected camera's
input, it triggers output signals on all the associated Alarm-Out connectors. You can also have the DVR's internal
buzzer sound if motion is detected on the selected camera.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in the
Alarm-Out setup screen (Schedule tab).
Highlight the box under the Notify heading and press the
highlighting Notification and pressing the
that item and pressing the
NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup screen and
the DVR should be registered in the RAS (Remote Administration System).
Figure 51 — Motion Detection Actions 2 screen.
38
button allows you to set up the Daytime range.
Highlight the box beside Daytime and press the
arrow buttons to set the Daytime range. The DVR will consider the remaining
time range as the Nighttime.
button. You can toggle the individual items On and Off by highlighting
button. Highlight OK and press the
The DVR can be set to react to motion detection differently
for each camera. Each camera can be associated with another
camera, trigger an Alarm-Out connector, sound the DVR's
internal buzzer, notify a number of different devices, move
PTZ cameras to preset positions, and/or display a camera on
a SPOT monitor.
NOTE: You can associate multiple cameras with a camera
that detects motion.
button. A list of cameras appears. You can associate
button. A list of Alarm Outputs appears. You can
button. You can toggle the entire list On and Off by
button to accept your changes.
Highlight the desired box under the PTZ heading, and press
the
button. A list of PTZ presets appear. Select the preset
position for each PTZ camera, where you want PTZ cameras
to move to whenever the DVR detects motion on the selected
camera's input.
Highlight the desired box under the Spot Monitor heading,
and press the
button. A list of SPOT monitors and cameras
appears. Each SPOT monitor can be associated with a camera.
The DVR will display the associated camera on the SPOT
monitor whenever it detects motions on the selected camera.
button. Use the Up and Down
Advertisement
Table of Contents
