Advertisement
MOTOR MOUNTING
Do not mount a motor on any of these kayaks.
CARE
&
STORAGE:
• These products are made of the highest quality materials and
comply with NMMA (National Marine Manufacturers Association)
regulations. Altering the construction of these products will void
the limited warranty and could jeopardize the safety of
the occupants.
• If your product has been used in salt water, rinse it off with fresh
water as soon as possible.
• Remove tar spots or other soiled areas by using a mild soap and
rinsing with fresh water.
• Be sure your product is completely dry before storing.
• The products may be stored inflated, but do not place any heavy
or sharp objects on it. Storage is best in a dry room.
18
REPAIRING SMALL PUNCTURES
For inadvertent punctures, you can repair them with the included
Sevylor'") repair patch.
INSTRUCTIONS:
1. Thoroughly clean and dry the damaged area. Completely deflate
if an inflatable article.
2. Cut a portion of the patch to cover the puncture, and allow an
additional W' on all sides. Always cut a round or oval patch.
Never leave corners.
3. Be sure the spot is completely dry.
4. Peel the backing from the patch.
5. Adhere the patch to the puncture.
6. Using your thumb or finger apply even pressure across the entire
surface of the patch.
The Sevylor'" AirSeal repair kit is also another repair option available
(Model
#
2000003730 - not included). Sevylor'" AirSeal is a fast,
reliable repair for vinyl inflatables: air mattresses, toys, pools, boats
as well as rainwear, groundsheets, golf bags, etc.
INSTRUCTIONS:
1. Thoroughly clean and dry the damaged area. Completely deflate
if an inflatable article.
2. When the damage is small (a pin hole or tear under 2 inches)
apply a light coat of AirSeal two or three times. Allow five minutes
to dry between each application.
3. For heavier material, e.g. fabric backed vinyl or a vinyl boat,
apply up to five coats allowing a five-minute drying period
between coats.
4. Ensure the AirSeal is completely dry before resuming use of
the article.
5. When the damage is more extensive, cut a patch (with rounded
corners) using any vinyl material. Generously coat the damaged
area spreading the AirSeal at least 3/8" from the torn edges.
Apply the patch and apply AirSeal to all edges of the patch
making a seal between patch and the item being repaired. Allow
the article to dry at least 10 hours before using.
AirSeal contains sufficient material for several small repairs.
AirSeal is intended for use with 100% PVC (poly vinyl chloride) only.
Do not use with any other material.
You may purchase the Sevylor® repair patch (Model
#
2000003731)
and Sevylor'" AirSeal (Model
#
2000003730) by calling Coleman
Customer Service at 1-800-835-3278 or going to www.sevylor.com.
19
Advertisement
