Advertisement
Outer
Chamber Valve
Installed
Seat
Seat Hook & Loop StriPS
12. Inflate outer chamber to 0.9 PSI.
10. Unfold kayak and install detachable fin to
connectors on bottom, rear of kayak, by
hooking the fin tabs mto the slots on
the connectors.
Note: Skip step 10 If model comes with
permanently attached fin
Kayak Hook &
Loop StriPS
Inflate Kayak (using order shown below)
9.
Turn seat over and set aside.
11 Inflate inner chamber to 0.9 PSI.
13. Take seat that was set aside in step 9, and
fold as shown.
14. Line up hook & loop strips on seat bottom with the hook & loop strips on the kayak floor. (See the
following image that show Installed seat)
Your QuikPak™ Kayak is now ready for use.
K3 QuikPak™
Breakdown/Storage Instructions
15. Connect seat backrest buckles to buckles
on kayak.
4.
Turn QUlkPak™ unit over and set aside.
1. Remove kayak seat
&
deflate kayak.
2.
Unfold kayak seat as shown in
figure above.
16. Adjust backrest straps to your
desired tension.
Kayak
3.
Pull shoulder straps back
through openings.
5. Fold kayak using the following steps.
Sa. Fold kayak lengthwise to center as
shown in the above Image.
10
11
Advertisement
