Toshiba RAS-4M23SAV-E Service Manual page 111

No. Part name
Fan motor 1) Perform work from item 1) to 5), 7) of
4
2) Remove the flange nut fixing the fan motor and
3) Remove the propeller fan.
4) Disconnect the connector for fan motor from the
5) Remove the fixing screws (4 pcs.), while holding
Compressor 1) Perform work of item
5
2) Evacuate refrigerant gas.
3) Remove the partition board.
4) Remove the sound-insulation materials.
5) Remove terminal cover of the compressor, and
6) Remove pipes connected to the compressor with
7) Remove the fixing screws of the bottom plate and
8) Remove the fixing screws of the bottom plate and
9) Pull upward the refrigeration cycle.
10) Remove nut fixing the compressor on the
6 Reactor 1) Perform work from item 1) to 5) of
2) Remove screws fixing the reactor.
Procedure
the propeller fan.
• Flange nut is loosened by turning clockwise.
(To tighten the flange nut, turn counterclock-wise.)
inverter.
by hands so that the fan motor does not fall.
1
(Take care that the reactor and the partition fixing
plate remain.) (Ø4 × 10L 3 pcs.)
disconnect lead wires of the compressor and the
compressor thermo. assembly from the terminal.
a burner.
heat exchanger. (Ø4 × 10L 2 pcs.)
valve clamping plate (Ø4 × 10L 2 pcs.), the
accumulator fixing plate and the accumlator (Ø4
× 10L 2 pcs.).
bottom plate.
(Ø4 × 10L 2 pcs. for one reactor. One outdoor
unit has two reactors on the partition.)
1 .
, ‚ and 4 .
2
1 and 2 .
– 111 –
Remarks
Flange nut
Propeller fan
Partition board
Reactor
Fan
motor
Valve
clamping
plate
Compressor
thermo.
Compressor