Toshiba RAS-4M23SAV-E Service Manual page 103

No. Part name
S
Electric parts 1) Follow the procedure up to 4) in
box assembly
2) Remove screw of earth lead attached to
3) Remove the lead wire cover, and remove
4) Pull out TC and TCJ sensors from sensor
5) Disengage the two claws at the top of the
6) Remove the fixing screw that secures the
<How to assemble the electric parts box>
1) Hook the top part of the electric parts box
2) Secure the grounding wire using the fixing
Procedures
the end plate of the evaporator.
connector (5P) for the fan motor and
connector (5P) for the louver motor from
the electric parts box assembly.
holder of the evaporator.
display unit.
(They can be easily disengaged by
pushing the drain pan above the claws
and at the same time pulling the display
unit toward you.)
electric parts box assembly, and remove
the assembly.
assembly onto the claws on the back
body, and secure it using the fixing screw.
Now attach the display unit.
Connect the connectors for the fan motor
and louver motor.
screw.
Insert the TC and TCJ sensors into the
sensor holder.
* Be absolutely sure to loop the grounding
wire, TC and TCJ sensor leads once at
the bottom.
R
above.
– 103 –
Remarks
TCJ sensor
Lead wire cover Lead wire cover
TC sensor TC sensor
Earth screw Earth screw
Fixing screw
Push the Push the
drain pan drain pan
Pull the display Pull the display
unit toward you unit toward you
TCJ sensor TCJ sensor
Fan motor Fan motor
connector connector
TC sensor TC sensor
Louver moter Louver moter
connector connector
Earth screw Earth screw
Make absolutely sure that
the leads form a loop