Cisco Catalyst 3750 Hardware Installation Manual page 133

Appendix C Connecting to DC Power
Use a ratcheting torque screwdriver to torque the terminal block captive screw (above the installed wire
Step 6
lead) to 4.5 lbf-in. (72 ozf-in.), as shown in
Caution Do not overtorque the terminal-block captive screws. The recommended maximum torque is 4.5 lbf-in.
(72 ozf-in.)
Figure C-8
Repeat Steps 4 and 5 for the remaining three DC-input power source wires.
Step 7
completed wiring of a terminal block plug.
Figure C-9
OL-6336-05
Torquing the Terminal-Block Captive Screws
Torque to 4.5 lbf-in. (72 ozf-in.)
Completed Wiring of Terminal Block Plug
Figure C-8.
Return
Feed A
Negative
Return
Feed B
Negative
Catalyst 3750 Switch Hardware Installation Guide
Connecting to DC Power
Figure C-9 shows the
C-7