System Setup And Configuration; Allocating Actuators To Zones - Assa Abloy Interlock Elevation Window Control System Installation And User Manual

SYSTEM SETUP AND CONFIGURATION

An Actuator can only be assigned to one Zone.

Allocating Actuators to Zones:

This screen will appear once the auto calibration is complete.
Press Yes to commence Zone Setup.
No will take you to the Home page where options of
Open All, Close All, and Setup will be available.
Note: There are a total of 30 Zone names to choose from.
Zone names cannot be customised.
See page 29 for the list of the names.
There are two ways to assign Actuators to zones:
1. If serial numbers are known (from page 26):
If not proceed to section 2 below.
Use the arrow keys to scroll, matching the serial number
on the left with the desired Zone on the right.
Press Add to Zone and confirm your selection.
2. If serial numbers are not known:
Press each Actuator button on the left.
The corresponding Actuator will open.
Note: After 5 minutes it will close automatically.
Visually locate this Actuator. Then use the arrow keys on the right
to select the desired Zone.
Press Add to Zone and confirm your selection.
The window will now close if open.
Note: Pressing the Actuator button again will also close the window.
Repeat either process until all Actuators are allocated to your
desired Zones.
Press Exit & Save then Yes to save your Zone settings.
5