Table of Contents
Advertisement
Quick Links
Econolift
Econolift
™
SECTIONAL/TILTING GARAGE DOOR OPENER
ML500 Econolift Sectional/Tilting
WARNING
Garage Door Opener
It is vital for the safety of persons to follow all
Installation Instructions
instructions. Failure to comply with the installation
instructions and the safety warnings may result in
serious personal injury and/or property and remote
OWNERS COPY
control opener damage.
Please save these instructions for future reference.
Advertisement
Table of Contents
Related Manuals for B&D Econolift ML500
Summary of Contents for B&D Econolift ML500
-
Page 1: Installation Instructions
Econolift Econolift ™ SECTIONAL/TILTING GARAGE DOOR OPENER ML500 Econolift Sectional/Tilting WARNING Garage Door Opener It is vital for the safety of persons to follow all Installation Instructions instructions. Failure to comply with the installation instructions and the safety warnings may result in serious personal injury and/or property and remote OWNERS COPY control opener damage. -
Page 2: Tools Required For Installation
Start by Reading These Important Safety Rules These safety alert symbols mean WARNING – a personal safety or property damage instruction. Read these instructions carefully. This garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the following safety rules. -
Page 3: Assembly Section
C C o o m m p p l l e e t t e e d d I I n n s s t t a a l l l l a a t t i i o o n n Assemble Cable Pulley Bracket As you proceed with the assembly, installation and adjustment Insert Carriage Bolt (1) though square hole in Cable Pulley Bracket (4). -
Page 4: Installation Section
Attach Rail to Unit Turn Rail assembly over. Wrap Chain around Drive Sprocket (1). Slide Rail assembly (2) toward unit and into slots on top of unit. Push Cable Pulley Bracket forward making Chain tight on sprocket. Chain MUST engage teeth on Drive Sprocket. Hang Opener Bend Hanging Brackets (1) so they are flat against ceiling. -
Page 5: Connect Door Arm To Trolley
Connect Door Arm to Trolley Setting the Force A. Preferred Installation: The Force is programmed to operate most doors, however, if Limits are not able to be set, or the door reverses during normal operation follow Disconnect Trolley by pulling on the red handle and slide towards door. this procedure: Locate the Program Button (1) on the left side panel of With door closed connect Straight Door Arm (5) to Trolley (4) with Bolt unit (2). -
Page 6: Specifications
Program Remotes Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Your garage door opener receiver and Remote Control Transmitter are set to a matching code. -
Page 7: Having A Problem
Operation Of Your Opener • If you have two or more remotes and only one operates, review receiver programming procedures in Step 21. Your opener can be activated by any of the following devices: • Is there a build-up of ice or snow under door? The door may be •... - Page 8 distributor in obtaining access where the Product is not readily accessible - you will need to pay for those additional expenses. Product: Econolift Automatic Garage Door Opener 5 What voids the warranty - Subject to clause 6, this warranty does not extend to, and B&D will be relieved of, all obligations, responsibilities and liabilities in the event that defects in the Product Purchased from:...