Anest Iwata LPH-80 Instruction Manual

HVLP Compliant Spray gun
LPH-80
Important
This manual contains IMPORTANT WARNINGS and INSTRUCTIONS.
Equipment in this manual is exclusively for painting purposes.
Do not use for other purposes.
The operator shall be fully conversant with the requirements stated in this
instruction manual including important warnings, cautions and operation and
correct handling.
Read and understand the instruction manual, before use and retain for
reference.
Be sure to observe warnings and cautions in this instruction manual.
If not, it can cause paint ejection and serious bodily injury by drawing organic solvent.
Be sure to observe following
Indicates a potentially hazardous situation which, if not avoided, may result in serious injury or loss of life.
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury or property
damage.
Indicates notes which we ask you to observe. The safety precautions in this instruction manual are the minimum
Important
necessary conditions. Follow national and local regulations regarding fire prevention, electricity and safety as well as
your own company regulations.
Important specifications
■
Max. Pressure
０．６８ ＭＰａ / ６．８ ｂａｒ / ９８ ＰＳＩ
Noise level
６０．３ ｄ Ｂ （Ａ）
Spray condition Recommended
Measuring point
1m backwards from gun,１．６ m height
Max. Temperature
Atmosphere
５℃～４０℃
Air・Fluid
５℃～４３℃
Main specifications
■
Nozzle
Type of
orifice
Model
feed
φmm (in)
LPH-80-042G
0.4(0.016)
-062G
0.6(0.024)
-082G
0.8(0.032)
-102G
1.0(0.039)
-122G
1.2(0.047)
Gravity
-044G
0.4(0.016)
-064G
0.6(0.024)
-084G
0.8(0.032)
-104G
1.0(0.039)
-124G
1.2(0.047)
※1. Atomizing air pressure means air pressure at gun inlet when trigger is pulled and air flows．
※2.Tested with 16sec / Ford cup #4 automotive repair paint.
Low Volume Low Pressure
marked items which are especially important.
Air cap
※1 Atomizing Air pressure inside
Set
air pressure
Mark
MPa (bar /PSI)
0.09
E2
(0.9/ 13)
0.10
E4
(1.0/ 14)
－ 1 －
This Anest-iwata spray gun kit complies to ATEX
regulations 94/9/EC,
Protection level ：
Ⅱ2 G X，Suitable for use in Zones 1 and 2.
X marking ：
Any static electricity discharge from the spray gun
is to be diverted to the grounded the conductive
air hose as stipulated.
Recommended conditio
※2
air cap Fluid output consumption
MPa (bar /PSI) ml/min l/min (cfm)
8
25
50 (1.8)
45
55
80
0.07
(0.7 /10)
10
30
45 60 (2.2)
60
75
Air & fluid
Air
※2
connection
Pattern width
mm (in)
40(1.6)
60(2.4)
80(3.2)
Air
100(3.9)
Ｇ1/4
120(4.7)
（NPS1/4）
55(2.1)
Fluid
80(3.1)
Ｇ1/8
100(3.9)
130(5.1)
140(5.5)
Mass
g (lbs)
205
(0.45)