Care And Cleaning - Hotpoint RB754N Use & Care Manual

A
WARNING
I
All ranges can tip.
Injury could result.
packed with the range.
. See Installation
the
Instructions.
STABILITY DEVICE INSTALLATION INSTRUCTIONS FOR BRAC~.T ~T NO. 342473
Tools needed:
Phillips
screwdriver
open end or adjustable wrench
wiring or plumbing. If this cannel be determined. use
shorter screws that will not penetrate through
attached to the lower range back. Remove and discard
1. Decide whether the bracket will be installed on the
right or Icfl side of the range location.
2. If the bracket side of the range is adjacent to a
cabinet, place the bracket against back wall and
cabinet as shown in Figure 1.
the location of the range side (painted outside
panel) will be. Place the bracket with its outside
edge at this location and against the back wall.
See Figure 1.
engages slot

CARE AND CLEANING

(continued)
3. Determine whether you will anchor [he bracket to
the iloor or wall. Fasten the bracket securely with
the screws provided. The screws are sell'-drilling in
wood, plywood, particle and chip board, and most
suitable screws and tinchors at hardware stores. Use
a masonry drill to drill the required holes.
4. Using the wrench, back out the tour leg levelers at
least two turns. See the Installation Instructions for
more level i ng information bel'ore positioning range,
5. Slide the range into place.
leveler fully engages the slot in the bracket, If
the range cannot be moved
the rear leg leveler to enter the bracket, move the
bracket forward as required and attach to the tloor
in the new location.
Attachment to wall
the rear leg
Be sure
back