Advertisement
Product Damage
Carefully push against the seal area of the
oven front frame when pushing the oven
into the cabinet.
Do Not push against outside edges.
Failure to follow these instructions
can
result in damage to oven finish.
Remove and discard shipping base. Lift
oven up into cabinet cutout using the oven
opening as an area to grip.
Push against seal area of front frame to push
oven into cabinet.
t 4 screws
w
Center oven into cabinet cutout. Use
. four screws through the mounting holes
in the front frame of the oven to secure the oven
to the cabinet. Do Not overtighten screws.
'd
ti
c/J
1 I
I '
I
__'
1 I
i
'
II
40
' 4,
..,* ,,
'w
/
B
' ,I
_.' /,
1 II
__,,_.~
&5
//
' II 1 II
__.' ,,"'
1
I "
" ,,"/
/,
c
3:--
"s
Use the one low-
\
profile
screw in
B
this Do&ion.
Install the lower vent grille using the
three screws provided.
110
n
Replaie the oven racks.
Replace the oven door
by partially fitting the
door hinges into the hinge slots. Pull door
slightly toward you; then slide door completely
in place. Reinstall the two oven-door screws (if
required for your oven door). If door does not
close, you have not pushed hinges completely
into frame. Repeat for lower oven door.
Panel C
Dual thermal convection double oven control panel
ml
Turn on the power supply. "88:88"
n
should appear in the clock display.
Press the "CLOCK SET" button. "TIME, HR AND
MIN" will light in the display. "0:OO" will appear
and ":" will-be flashing. Press the numbers pads
for the correct time of day. Press the
'START/ENTER"
pad to start the clock.
1131
Check the operation of the BROIL
. elements.
h
1
1121
Check the operation of the BAKE
W element.
Both ovens:
Press the oven "UPPER" or
"LOWER" pad. Then press the "BAKE' pad and
"350"" will appear in the display. Press the
"START/ENTER"
pad to start the bake
operation. "Lo"" and the "ON," Bake Element,
Outer Broil Element and Oven Cavity symbols
will light in the display. In l-2 minutes, the
bottom element should glow red. The upper
element should become hot, but not glow red
and the oven should be heating.
Press the appropriate "UPPER OVEN" or
"LOWER OVEN" "CANCEL/OFF"
pad.
Both ovens:
Press the oven "UPPER" or
"LOWER" pad. Then press the "BROIL" pad and
"500"" will appear in the display. Press the
"START/ENTER"
pad to start the broil
operation. The "ON," Inner and Outer Broil
Elements, and Oven Cavity symbols will light in
the display. In 1-2 minutes, the upper elements
should glow red.
Press the appropriate "UPPER OVEN" or
"LOWER OVEN" "CANCEL/OFF"
pad.
To get the most efficient use
from your new oven,
read your KitchenAid
Use &
Care Guide. Keep Installation
Instructions
and Guide close to
oven for easy reference.
Numbers
correspol
to steps.
Id
Advertisement
