Step 7 Locating The Dhcp Allocated Ip Address - Dedicated Micros dv-ip Setup Manual

6. In HyperTerminal, log on to the DV-IP Server by typing +++ and pressing enter.
7. At the DV-IP> command prompt, type the following commands, replacing <aaa.bbb.ccc.ddd> with
the values issued by the Network Administrator.
<ESC> denotes the Escape button on your keyboard, <ENTER> denotes the enter key on your
keyboard.
<ESC>m\ether_ip\000.000.000.000 <ENTER>
<ESC>m\subnet\000.000.000.000 <ENTER>
<ESC>m\gateway\000.000.000.000<ENTER>
<ESC>m\save <ENTER>
reset (to restart the DV-IP Server) - you must reset the DV-IP Server for the settings to be applied.
The DV-IP Server will automatically be allocated an IP address from the DHCP server.

Step 7 Locating the DHCP Allocated IP Address

If the unit has been left at default setting then the unit will be automatically allocated an IP address, it is
important to find this information before the configuration of the unit can be carried out.
The DV-IP Server must be connected to the DHCP network during this procedure.
Note: Although this configuration provides an IP address for the DV-IP Server unit
using the DHCP protocol, the IP address is only temporary, so it is advised that a
permanent IP address is provided manually at a later date.
8. Connect to DV-IP Server using Hyper Terminal as described in Allocating and IP Address above.
9. At the DV-IP> prompt in HyperTerminal, run the IP configuration tool, type:
ipcfg<ENTER> - the DHCP IP address assigned is displayed.
10. Make a note of the IP address for testing the network configuration.
IP address
Subnet mask
Gateway
(if required)
Dedicated Micros Ltd
.
for example 172.16.0.100
.
for example 255.255.0.0
.
for example 172.16.0.254
. .
. .
. .
Page 33