Installing The Dv-Ip Server; Dv-Ip Server Connections And Leds; Rear Panel Connection - Dedicated Micros dv-ip Setup Manual

Installing the DV-IP Server

The Installation of the DV-IP Server can be carried out in simple steps as described in the Quick Start
Guide; this section will elaborate on this information and the connectivity required for the Advanced
features supported on the DV-IP Server.
In addition to detailing the physical connectivity this section also describes some aspects of
configuration that are required to be carried out at installation stage, these are all the serially configured
parameters of the Server.
The installation of the DV-IP Server can be separated into:
Simple installation -
Advanced installation - project based requirements such as alarms, external storage,
and audio

DV-IP Server Connections and LEDs

Rear Panel Connection

Serial Ports
COM 2 COM 1 COM 3
OUT
IN
POWER
AUDIO1
NET
Power Network
Audio
Connection
Video
VID1 to VID16 75Ω BNC composite camera connections, 1V pk-pk (loop through bottom row)
Dedicated Micros Ltd
essential components required for the unit to operate
485 Bus
COM 4
TERM
485 BUS
A
OUT
B
IN
AUDIO2 MON VID 1 VID 2
Alarms and Relays
ALARMS IN
R5 R6 + AUX -
VID 3 VID 4 VID 5 VID 6 VID 7
Video connections - top row
Loop through - bottom row
SCSI
SCSI
RELAYS 1 - 4
VID 11
VID 8 VID 9 VID 10 VID 12 VID 13 VID 14 VID 15 VID 16
Page 17