Parking Calls - Broadconnect IP Office 1408 User Manual

5.2 Parking Calls

Parking a call is similar to holding a call. However parked calls can be unparked by other users on the phone system.
Each parked call is given a number. By default the number is your extension number plus a digit.
Calls that you have parked will return to your phone if they remain parked for too long. The default return delay is 5
minutes. This is a system delay that is applied to all users and can be changed by the system administrator. Returning
calls ignore any forwarding or do not disturb settings.
If you park a call without specifying a park slot number, the system will assign a number based on your extension number
plus a single digit. For example for extension 201, the first parked call will use park slot number 2010 if available. If you
already have one parked call, the next parked call will use park slot 2011 if available.
Call park buttons can be configured with a specific park slot numbers. A calls parked using that button will be given that
park slot number. Any other users with a call park button set to the same number will see that there is a parked call and
can unpark it using their button.
A feature button set to the
116
number, the button will indicate when another user has parked a call using that park slot number.
Default Short Codes
Short codes are numbers that you can dial to enable and disable various features. The following are default short codes
that may be available. Your system administrator will confirm any additional short codes that they may have configured
for your use.
· Park Call: *37*N#
Parks the held call using the park number dialed in place of N.
· Unpark Call: *38*N#
Unpark the call parked using the park number N.
1408, 1416 Phone User Guide
IP Office
Call Park action can be used to park and unpark calls. If configured to a specific park
119
Holding and Parking Calls: Holding Calls
15-601040 Issue 06a (25 October 2011)
Page 49