Page 2
A-14 & A-34 Installation Manual Thank you for purchasing our product. If there are any questions, or requests, please do not hesitate to contact the dealer. This manual may contain inaccuracies or printing errors, and the content is subject to change without notice.
A-14 & A-34 Installation Manual Safety Instruction These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss. The precaution measure is divided into ‘Warnings’ and ‘Cautions’: Warnings: Serious injury or death may be caused if any of these warnings are neglected.
Page 4
A-14 & A-34 Installation Manual Notice: Make sure the power supply voltage is correct before using the camera. Do not drop the camera or subject it to physical shock. Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of ethanol and wipe it gently.
This built-in video server provides the capability of providing real-time video stream compression, processing, video analysis and transmission simultaneously. Applying the latest processing chip and hardware platform, Advidia network cameras can be widely applied to various surveillance and image processing systems with high reliability and stability.
A-14 & A-34 Installation Manual Chapter 2 Dome Camera Installation 2.1 Dome Camera A-14,A-34, A-34W 2.1.1 Overview Figure 2-1 Overview Physical Description Table 2-1 Description Mounting base Horizontal stand Vertical stand Lower dome Cables Plate of infrared lamp Lens Black Liner...
Installation Manual of Network Camera 2.1.2 Installation Notes: Read the following contents carefully before the installation. Check the specification of the products for the installation environment. Make sure that all the related equipment is power-off during the installation. ...
Page 9
Installation Manual of Network Camera Figure 2-3 Remove the Lower Dome 3. Secure the mounting base to the ceiling with screws. Figure 2-4 Fix the Mounting Base Note: If required, you can route cables through the side opening on the side of the mounting base.
Page 10
Installation Manual of Network Camera 4. Loosen the tilt lock screws, adjust the tilting position in a range of 65 degrees, and tighten the tilt lock screws. Rotate the black liner to adjust the panning position in a range of 360 degrees until getting the desired surveillance angle Figure 2-6 Angle Adjusting Note:...