Samsung SMARTCAM SNH-E6440BN User Manual page 59

Motion zone
Cancel Clear OK
1. Tap the motion zone icon.
2. Connect to the motion zone mode.
3. After touching the video, drag it to set the area.

You can set a max of three motion zones.
4. If you want to run the motion zone in the area set, tap
<OK>.

Motion is detected only in the set area.

Motion zone function only operates if motion detection is activated. In
<Setup> - <Event>, set motion detection.
5. To delete the set area, press <Clear> and <OK>.
If you want to exit the motion zone setting mode, tap
<Cancel>.
To control digital zooming
You can also zoom in by pinch open using two
fingers on the screen. To zoom out, pinch close
on the screen.
Touch and hold to drag the screen in any
direction to reveal the hidden part of the image
if enlarged bigger than the screen.

M
Current digital zooming level is noted next to the digital zoom box,
and digital zooming supports zooming up to x4.
Relay mode
If the network condition is not good and a connection is
unstable, then you can use the relay mode to view video for
seven minutes.
When the relay mode connection is made, the [
displayed on the video, and to maintain stable connections,
there will be no audio or HQ video.

J
If the router UPnP setting is not set, then a relay mode connection
can be made. Depending on the model of router used, a different
setting method is used. Refer to the user manual.

If a camera is connected to the multiple router, or the wired/wireless
network environments for camera and mobile device are unstable, a
relay mode connection can be made.

If you have trouble connection to the camera, visit "http://www.
samsungsmartcam.com", go to support page, and refer to
"Troubleshooting" on it.
5. Camera Setup
Tap the <Setup> icon to configure a camera to be monitored.
List test Back Setup
test
General
Network
test
Time
Event
Live Event Playback Setup
SD Card
General setting
1. Tap <General>.
2. Configure the basic camera
] mark is settings.
• Camera Name : Camera name is
used to easily identify the camera
when you have more than one.
• Speaker/Mic : Adjust the
volume for the camera's built-in
mic or speaker.

M
If you set the mic to zero, there will be no
live sound and no audio event and also
there is no recording in the SD card.
• Audio REC : The voice can be
recorded or deleted by users.
• Night Vision : Set the IR lighting.
Check <Night Vision> to set
the camera to switch to the
night vision mode automatically.

M
In the case of SNH-1010N, you can
check <Night Vision> for a
camera to automatically operate the
IR lighting for two minutes
depending on the brightness of the
neighboring areas.
• WDR : You can compensate for
the backlight by making a dark
area brighter, and a bright area
darker.

SNH-P6410BN supported
• Display date : Displays the date/
time on the live video.
• Save camera password : You
will be connected to your
camera without having to enter
the password.
• Change camera password :
Change the current camera
password.
General
Back Apply
Camera Name test
Speaker
Mic
Audio REC
Night Vision
WDR
Display date
Save camera password
Change camera password
Audio List
Back
01. Add personalized audio clip
02. Add personalized audio clip
03. Add personalized audio clip
04. Add personalized audio clip
05. Add personalized audio clip
06. Add personalized audio clip
07. Add personalized audio clip
08. Add personalized audio clip
09. Add personalized audio clip
10. Add personalized audio clip
Password
Back Apply
Current Password
New Password
Use 1 - 8 numbers and/or letters
Confirm password
Show Password
If you don't want to save camera password,
please go to settings to disable "Save
camera password".