Installation - NEC MultiSync LCD1700NX A Service Manual

english – 4 User's Manual

Installation

To install the monitor to your host system, please follow the steps as given below:
Steps
1. Open the connector cover first.
2. And then open the cable cover.
3. Connect Video Cable
a. Make sure both the monitor and computer are powered-OFF.
b. Digital: Connect the DVI signal cable to the connector of the computer first, then to the monitor.
Analog: Connect the 15-pin mini D-SUB signal cable to the connector of the computer first, then to
the monitor.
4. Connect power cord
Check first to make sure that the power cord you use is the correct type required for your area. Connect the
AC Adapter cord to the monitor.
Connect the power cord to the AC Adapter, then to a properly grounded AC outlet.
5. Assemble the cable cover.
6. Cover the connector cover.
7. Power-ON Monitor and Computer
Power-ON the monitor first, then power-ON the computer.
This sequence is very important.
8. If the monitor still does not function properly, please refer to the troubleshooting section to diagnose the
problem.
Connector Cover
D-Sub Cable
DVI-D Cable
(not included)
Cable Cover
(This semi-circle opening is the Cables outlet)
1-33