Table of Contents
Advertisement
1 2 3 4 5 6
1 2 3 4 5 6
INSTALLATION SET-UP
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
Before Installation
The installation procedure is different according to the projection system and screen size. From the factory the projector is set for
ceiling mount, 100 inch diagonal screen size and a projection angle of 12.4 degrees (XG75A)/12.2 degrees (XG110LC/XG135LC).
Installation and preliminary adjustments are required as shown on table below.
Projection type
Ceiling mounting Front projection
Desk top Front projection type
Ceiling mounting/Rear projection
Desk top Rear projection
NOTE: For XG75A, the "100 inch" covers the range of screen size between 80 and 129 inches. For XG110LC/XG135LC, The ''100
inch'' covers the range of screen size between 90 and 109 inches.
NOTE: Focus ring adjustment on pages 15 and 16 for XG75A, and 17 and 18 for XG110LC/XG135LC.
Carrying the Projector
WARNING:
Be sure to use the handles when carrying the projector.
Pulling Out the Handle
Pull out the handle from the bottom side.
INSTRUCTION.
Adjustment
items
Various
Screen size
adjustments
(diagonal)
100 inch
None
other than 100 inch
Yes
100 inch
Yes
other than 100 inch
Yes
100 inch
Yes
other than 100 inch
Yes
100 inch
Yes
other than 100 inch
Yes
3
H Polarity
Focus ring and CRT angle change
change
None (Set the focus ring when changing projection angle)
None
None
None (Set the focus ring when changing projection angle)
Yes
Yes
None (Set the focus ring when changing projection angle)
Yes
Yes
None (Set the focus ring when changing projection angle)
None
None
Retracting the Handle
Press down the two levers at the same time to retract the
handle.
Yes
Yes
Yes
Yes
Advertisement
Table of Contents
