Figure 56 - Fault Inhibit Option; Figure 57 - Entering Card Test Options - General Monitors TA102A Instruction Manual

5.4.7 Card Test Options
After the Fault/Inhibit option has been selected, the user will select the ramp time (3 or
10 seconds) and whether or not the alarm outputs will activate during a Card Test. The
display will indicate ct for about five seconds (Figure 57) followed by the ramp up time
(3 or 10) during the card test (Figure 58). 3 is the factory default for this selection.
TA102A
0 - 100% LEL
READY
FLASHING FAULT LED
FAULT
SETUP LED
SETUP
FLASHING for SETUP
CHECK MODE,
STEADY FOR SETUP MODE
MODE/
SELECT
GENERAL
MONITORS
Figure 56 – Fault Inhibit Option
TA102A
0 - 100% LEL
READY
SETUP LED
SETUP
FLASHING for SETUP
CHECK MODE,
STEADY FOR SETUP MODE
MODE/
SELECT
GENERAL
MONITORS
Figure 57 – Entering Card Test Options
31
Model TA102A
TA102A
0 - 100% LEL
READY
FAULT
SETUP
MODE/
SELECT
GENERAL
MONITORS