Warnings - General Monitors TA102A Instruction Manual

Model TA102A
Warranty Statement
General Monitors warrants the Model TA102A to be free from defects in workmanship
or material under normal use and service within two (2) years from the date of
shipment. General Monitors will repair or replace without charge any such equipment
found to be defective during the warranty period. Full determination of the nature of,
and responsibility for, defective or damaged equipment will be made by General
Monitors' personnel. Defective or damaged equipment must be shipped prepaid to
General Monitors' plant or the representative from which shipment was made. In all
cases, this warranty is limited to the cost of the equipment supplied by General
Monitors. The customer will assume all liability for the misuse of this equipment by its
employees or other personnel. All warranties are contingent upon proper use in the
application for which the product was intended and do not cover products which have
been modified or repaired without General Monitors' approval or which have been
subjected to neglect, accident, improper installation or application, or on which the
original identification marks have been removed or altered. Except for the express
warranty stated above, General Monitors disclaims all warranties with regard to the
products sold, including all implied warranties of merchantability and fitness and the
express warranties stated herein are in lieu of all obligations or liabilities on the part of
General Monitors for damages including, but not limited to, consequential damages
arising out of/or in connection with the use or performance of the product.

Warnings

WARNING - COMBUSTIBLE & FLAMMABLE GASES AND VAPORS ARE VERY
DANGEROUS. EXTREME CAUTION SHOULD BE USED WHEN COMBUSTIBLE &
FLAMMABLE GASES AND VAPORS ARE PRESENT.
All Zero Two Series Modules contain components, which can be damaged by static
electricity. Special care must be taken when wiring the system to ensure that only the
connection points are touched.
WARNING - suitably skilled and competent personnel must carry out Installation and
Maintenance only.
Full backward compatibility can be specified at the time of order. If this configuration is
specified, the rear terminal output designations will be identical to the previous
generation of Zero Two Series Modules.
This generation of product can be distinguished from the previous generation by the
lack of a door on the front panel. Adjustments are not necessary on the current
generation of this product.
i