Inhibit Mode; Figure 48 - Entering The Password; Figure 49 - Entering Inhibit Mode - General Monitors TA102A Instruction Manual

Figure 48 – Entering the Password

5.4.2 Inhibit Mode

This option applies to the Setup Mode only:
• If the password option is disabled, or after the correct password has been entered,
the display will indicate In for five seconds (Figure 49). Pressing the Mode/Select
switch while In is displayed, will cause the unit to enter the Inhibit mode by inhibiting
the alarm outputs. As the unit enters the Inhibit mode, the Model TA102A will
automatically return to normal operation. If it is desired to enter the Setup Mode, do
not press the Mode/Select switch for the five seconds that In is displayed.
Figure 49 – Entering Inhibit Mode
TA102A
RIGHT DIGIT
IS BLANK
LEFT DIGIT
0 - 100% LEL
IS BLANK
READY
STEADY SETUP LED
SETUP
(SETUP MODE ONLY)
MODE/
SELECT
MODE/SELECT
GENERAL
MONITORS
SWITCH
TA102A
0 - 100% LEL
READY
STEADY SETUP LED
SETUP
(SETUP MODE ONLY)
MODE/
SELECT
MODE/SELECT
GENERAL
MONITORS
SWITCH
26
Model TA102A
TA102A
0 - 100% LEL
READY
SETUP
MODE/
SELECT
GENERAL
MONITORS