Download Print this page

Error Codes - Belling 60cm User Manual

Hide thumbs

Advertisement

Heater display
F0
Touch control
software error.
Fc or F
Touch control is
too hot and has
turned off the
heaters.
Ft
Touch control
temperature
sensor may be
damaged.
FE
Touch control
temperature
sensor may be
damaged.
FL
Extreme ambient
light conditions
on initial set-up.
FJ
Security soft-
ware error
FU
Security soft-
ware error.
FA
Security soft-
ware error.
Fr
Relay operation.

ERROR CODES

Fault
If error has occurred after initial cali-
bration (see initial power on) discon-
nect and reconnect the power from the
hob again, re-calibrate the hob again,
if the error persists or appears again in
normal use, call customer services.
Wait until the temperature goes down.
Hob will automatically start again once
it reaches normal temperature.
You may have to switch the power off
and on to reset the fault code.
Wait until the temperature goes down.
If the message persists after the hob
cools down call customer service.
Wait until the temperature goes down.
If the message persists after the hob
cools down call customer service.
See initial power on to resolve.
This error is a software auto check. It
disappears when auto-check returns to
normal value, If error persits call cus-
tomer service.
This error is a software auto check. It
disappears when auto-check returns to
normal value, If error persits call cus-
tomer service.
This error is a software auto check. It
disappears when auto-check returns to
normal value, If error persits call cus-
tomer service.
This error is an autocheck for the mi-
croprocessor signals that control the
heater relays operation. Disconnect the
hob to the main switch, wait several
seconds and connect again. Program
the hob as usual. If the error persists,
call customer service.
Action

Hide quick links:

Advertisement

loading

This manual is also suitable for:

70cm90cm