Belling 60cm User Manual page 5

USING THE HOB - ELECTRIC (CERAMIC)
WARNINGS
• Do not use the ceramic hob if the
glass surface is cracked, as electrical
parts are directly beneath. Switch
off the appliance at the supply to
prevent electric shock and contact
your supplier.
• The hob surface remains hot after
use. DO NOT TOUCH.
• The appliance is not intended to be
operated by means of an external
timer or separate control system.
Initial Power On and calibration
• When the hob is fi rst connected to
the mains supply, the hob will appear
in childlock mode and a red neon is
illuminated.
• Before use the hob needs to be
calibrated. For this it is important that
any bright lights above the hob are
switched off, eg. halogen hood lights.
• To calibrate and unlock the hob,
touch the key symbol and the red
neon goes out, and a beep is heard.
• The hob is now calibrated and ready
for use.
Switching on the hob
• Touch and hold the on/off symbol for
3 secs. The hob will beep and all en-
ergy level indicators will display "0".
• If no other symbol is selected within
10 secs the hob will turn off.
Operating a heater
• Select the desired heater by touching
its own symbol. The corresponding
display will fl ash "0". Touch "+" or "-"
to set the power level. After 10 secs
the display will stop fl ashing and a
beep is heard.
• To adjust the power level, touch
the heater symbol until the display
fl ashes. Adjust the "+" or "-" to the
desired power level. After 10 secs the
display will stop fl ashing and a beep
is heard.
Switching a heater off
• To turn off a heater, touch and hold
the desired heater symbol until the
display fl ashes. Adjust the "-" symbol
down to "0". After 10 secs the heater
will switch off, the display will stop
fl ashing and a beep is heard.
• To turn off all heaters together, touch
and hold the on/off symbol for 1 sec.
Notes on use
• The power settings on the hob do
not indicate any set temperature and
cannot be used to judge one element
against another.
• During cooking, the elements will
cycle on and off. This is normal.
Dual Zone (if fi tted)
• Select the dual zone heater by touch-
ing its inner symbol. The correspond-
ing display will fl ash "0". Touch "+"
or "-" to set the power level. If you
require the outer heater, while the
power level is fl ashing touch and hold
the outer symbol. After 10 secs the
display will stop fl ashing and a beep
is heard.
Auto heat-up
• Select the desired heater by touch-
ing its own symbol. The correspond-
ing display will fl ash "0". Touch "+"
until 9 is reached then press the "+"
again. A dot will appear next to the
"9." and they will both start to fl ash
for 10 secs. This indicates that auto
heatup is on. During this time the de-
sired power level must be set. After
10 secs a bleep sounds and the dot
becomes fi xed. The heater will be set
at this level.
• If "0" or "9" are selected whilst in
auto heatup mode the function is
cancelled