Software Setup - Matrox DualHead2Go Series User Manual

Software setup

This section describes how to install Matrox software for Windows
2000/XP.
You may need administrator rights to install certain software. For
more information, see Windows documentation or contact your
system administrator.
Note:
display on your secondary display.
Install your Matrox software
1
Insert the Matrox installation CD-ROM in your CD-ROM drive – the CD-ROM installation
program automatically starts.
Configure your monitor settings
2
To get the most of your Matrox product, make sure you have the correct monitor settings
selected in Windows:
Note:
one or both displays may be unusable. For more information on the display modes your
Matrox product supports,
Right-click your Windows desktop background, then click
a
Under
b
stretched mode resolution (for example, 2048 × 768).
Click
c
For more information on Windows monitor settings, see Windows documentation.
* If Windows doesn't automatically start the setup program, you can run the setup program from the Umbrella folder of the
CD-ROM.
While using a 1024 × 768 display resolution, you can view a copy of your main
*
Follow the on-screen instructions.
While an unsupported display mode (display resolution and refresh rate) is selected,
see "Supported display modes", page
(Windows 2000) or
Screen area
" .
OK Yes
13.
Properties
(Windows XP), select a
Screen resolution
Matrox DualHead2Go Series – User Guide
.
"
Settings
5