Connection Setup - Matrox DualHead2Go Series User Manual

Connection setup

This section describes how to connect monitors to your Matrox product.
Note:
your Matrox product, we recommend you use two identical monitors (that is, monitors
that support the same settings such as display resolution and refresh rate). For information
on the settings your monitor supports, see your monitor documentation.
Adjust the display mode
1
Note:
one or both displays may be unusable. For more information on the display modes your
Matrox product supports,
Windows 2000/XP –
Right-click your Windows desktop background, then click
a
b Move the
1024 × 768, then click
Click
c
Under
d
60 Hertz
Click
e
Turn off computer
2
To shut down your computer, click
computer.
WARNING:
your computer is turned on, it may be using monitor settings that are specific to the current
monitor connections. Some devices may be permanently damaged if incorrect settings are
used.
Your Matrox product supports up to 2 analog monitors at a time. To get the most of
While an unsupported display mode (display resolution and refresh rate) is selected,
see "Supported display modes", page
(Windows 2000) or
Screen area
Apply
.
"
Advanced Monitor
(Windows 2000) or
Refresh frequency
.
" .
OK Yes
Don't change monitor connections while your computer is turned on. While
Screen resolution
.
Screen refresh rate
" "
Start Shut Down Shut down
Matrox DualHead2Go Series – User Guide
13.
.
"
Properties Settings
(Windows XP) slider to
(Windows XP), select
" , then turn off your
OK
3