Comfort Adjustments; Tiller Angle Adjustment; Seat Height Adjustment - Pride Sundancer Owner's Manual

V I I . C O M F O R T
WARNING! Remove the key before adjusting
the tiller or the seat. Never attempt to adjust
the tiller or the seat while your scooter is in
motion.

TILLER ANGLE ADJUSTMENT

You can adjust the tiller to any number of positions between
the forward stop and the scooter deck. The tiller adjustment
lever keeps the tiller in place.
1. Push down on the tiller adjustment lever. See figure 9.
2. Move the tiller to a comfortable position.
3. Release the tiller adjustment lever. The tiller remains
in the position you selected.
NOTE: In order to lower the tiller to the scooter deck, you must first remove the seat and both batteries.
See VIII. “Disassembly and Assembly.”

SEAT HEIGHT ADJUSTMENT

The seat can be repositioned to one of three different heights. See figure 10.
1. Remove the seat and rear shroud from your Scooter. See VIII. “Disassembly and Assembly.”
2. Use the attached ring to pull and remove the ball detent pin from the seat post tower.
3. Raise or lower the seat post to the desired seat height.
4. Hold the seat post at that height and match up the locating holes in the seat post with those in the seat post
tower.
5. Fully insert the ball detent pin.
SEAT POST TOWER
22
A D J U S T M E N T S
Figure 10. Seat Height Adjustment
Figure 9. Tiller Angle Adjustment
SEAT POST
BALL DETENT PIN
TILLER ADJUSTMENT
LEVER
LOCATING HOLES
Sundancer