Pride Sundancer Owner's Manual page 27

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
12. Separate the front section from the rear section. See figure 20.
ASSEMBLY
1. Place the freewheel lever in the drive (down) position.
2. Position the front and rear sections next to each other.
3. Tilt the rear end to a horizontal position and insert the longer tube of the front end into the rear section first;
make sure that the cam lock levers are vertically positioned and the locking pins are removed.
4. Slide the two sections of the unit together until the front half reaches its insertion limit.
5. Secure the front and rear sections with the ball detent pins.
6. Ensure the tiller is in an upright position.
7. Push the cam lock levers back to their locked (down) position.
8. Clip the front basket onto the front of the tiller.
9. If you removed the utility tray from the rear component, replace the tray by aligning the reusable fasteners on
the utility tray with those on the rear component; gently press down on the utility tray to ensure it is secure.
10. Plug the large, white, front-to-rear connector located on the harness coming from the front section into the
mating plug found on the electronic controller module. The two orange dots present on both plugs should be
adjacent to each other and enable quick plug mating.
11. Put the batteries in place and plug both 2-pin battery harnesses into the adjoining harnesses that are also
located on the electronic controller module. Refasten the battery tie-down strap.
12. If you removed the utility tray from the rear component, connect the 6-pin motor harness plug.
13. Gently place the rear shroud over the seat post tower.
14. Connect the rear light harness, if so equipped. Make sure that the rear plastic shroud does not make any
contact with the rear wheels.
15. Slide the shroud down in place.
16. Carefully lift the seat and slide the small seat pedestal (on the seat bottom) into the seat post tower.
Sundancer 27